Help needed after WirePlus.

[1mndg]

Ok. Here it is. Installed my WirePlus a few weeks ago and everything is working great except for two small problems. (Great product by the way) Problem 1: I can't get my tach to work. Where does it get its signal from or am I missing something. Checked the wiring a few times and everything seems to be hooked up right. Problem 2: when I pull the front brake lever, no brake lights. Back ones work fine and they did work before the rewire. Again it looks like all is wire correct. Is it something with the magnetic switch. Any help will be greatly appreciated and Thanks in advance for your help.

 

[Little-Boo]

Here are the Instructions I have for the Tach


BDM yellow wire and green wire from Pin #B47 & A5. These are the Tach signal and tach input wires. Soldered them together and shrink wrapped. They do not get pins on them, Fold them back Into the harness as well:

Hope that helps. You may need to adjust the magnet on the brake lever or take a look at it and make sure the wire didn't break of the circuit board.

Carlos