Help Bike wont start

Little-Boo

Well-Known Member
Troop Supporter
Check this link out

http://www.bigdogbiker.com/forums/h...tarter-wont-turn.html?highlight=solenoid+test

Do a search on "Bike won't start" and see what others have found the issue to be. You are saying the starter may be bad, how about the battery how old is it and do you kept it on a battery tender. Do not attempt to jump start the bike with jumper cables or you could fry the EHC. Have you tried to push start it, put it in 4th gear have someone help push and see if it will start. You may want to take the starter off and take it to an auto motive electrical repair service like Escobar's in Weslaco, Texas. Have them check the starter to see if it is in working condition before you buy one. Try the link above and diagnose it yourself. I think your starters is a 2.0 Spykes Starter for right side drive. That is what I have on my 2006 Mastiff. I live in McAllen, if you need any help let me know maybe we can hook up and get your dog going.

Carlos :whoop:
 

migai082681

Member
I think it the starter when i crank it it struggles to turn over the motor. When i take the plugs the motor spins freely
 

Brew

Troop Supporter
Make sure your compression releases are working. See if they both go down when you push the run switch. A weak battery can cause this to happen also...
 

Little-Boo

Well-Known Member
Troop Supporter
I think it the starter when i crank it it struggles to turn over the motor. When i take the plugs the motor spins freely
That tell me you need a new battery. If the starter was bad it would not spin your motor at all. I would get a New Battery it takes one with hugh balls to turn this motors. Harley sells the AGM that has 310 CCA for about 100 bucks. Don't buy a battery with less than 310 CCA. Lot of riders on here use that battery

This is the one I use it has 465 CCA

Tomioka Racing TR-B1500 Performance Lightweight Battery

Carlos :2thumbs:
 

Raywood

The Pirate
Staff member
Calendar Participant
Troop Supporter
I got a brand new brille battery, and as for the compression releases have to press manualy
Why? They are electronic and work automatically

Put a volt meter on your battery and ensure your getting 12.8 volts minimum when starting. And make sure all your wires are tight with good connections
 

Little-Boo

Well-Known Member
Troop Supporter
I got a brand new brille battery, and as for the compression releases have to press manualy
That doesn't mean the Battery is good you should have it test loaded and see what its putting out. if It is less than 12.V it will not start your bike. FYI I have gone through 1 BDM battery, 1 Big Boar and 2 Braille in the last 6 years so. The best I have found this far is the TR-B1550 with 465 CCA.

Carlos :2thumbs:
 
Top