Heads and Jugs Polished?

[mittens]

Who can I send them off to, to have them all cleaned and re polished?

I have found the dimond cutting people, but they dont polish or powdercoat. Just the cutting.

I also reached out to Meltec, and no answer or response yet. Going to replace base gaskets and head gaskets would like to make motor shinnyy again now that its 20 years old.

 

[Jersey James]

You can polish them yourself, for much cheaper. And lots easier now that they are off. Plus the satisfaction that you did it yourself. Plenty of aluminum polishing how to do, here and on the web. JJ

 

[Chong]

Some have used modified electric knife.
Cut off blades, and attach paint stir stick.
Liferider has this detailed out.

Below is link that uses a oscillating cutting tool.
I would be using bondo squeegee to make the tools probably.

 

[mittens]

Great link and idea!. I may just very well do that once they are off.

But i would like to know if there is a place that does it and the cost? maybe they do both polish and Cut? but that video will make it look a lot better for sure.

 

[Shredder]

I sent mine to Sumax for powder coating and they have a relationship with Diamond cuts heads and then sends them directly to them for cutting.

 

[john sachs]

You may want to look into a chrome plating shop, for just polishing.
John

 

[mittens]

I assume you cant just Chrome the heads and jugs haha (i assume heat is the issue then)

Sure would make this whole thing easier to clean! hahaha

 

[mittens]

Not to hate on some info but that's the exact link posted 4 post above... someone not readying threads ha.

And while it does work, that does not get the Ruff casting marks, off its only good to get to the already polished areas.