Handlebar cicuit boards

[Raywood]

My horn was blaring and lost headlight control. Pulled circuit card and found this! Replaced and all is well. Clickers are separating and loosing contact. Seems laminating layer of contacts dries out and the clicker part moves beyond the contacts on the board.



Sent from my DROID RAZR using Tapatalk 2

 

[pauldeepsea]

My born was blaring and lost headlight control. Pulled circuit card and found this! Replaced and all is well. Clickers are seperating and loosing contact

Sent from my DROID RAZR using Tapatalk 2

damn auto correct! "HORN" did this start after you lost your kickstand???

 

[Raywood]

Picture my not show it correctly but the clicker thing will move around and not make contact with the board

Sent from my DROID RAZR using Tapatalk 2

 

[pauldeepsea]

Picture my not show it correctly but the clicker thing will move around and not make contact with the board

Sent from my DROID RAZR using Tapatalk 2

Ray if I am correct you should be able to get replacements through Harley.

 

[Raywood]

Ray if I am correct you should be able to get replacements through Harley.

HD has nothing like this, its BDM specific



Sent from my DROID RAZR using Tapatalk 2

 

[shovelshot]

What's a horn?

 

[V]

Your ride is at 100,000 on the meter. It deserves to blow its horn!

:2thumbs:

 

[kickstart]

Ray, just in case you didn't know there was a RED SERVICE BULLETIN (URGENT) SB-1069A issued 03NOV06. It covered all 2005 and early production 2006. The Corrective Action was to replace the boards with REV. F boards.

My horn was blaring and lost headlight control. Pulled circuit card and found this! Replaced and all is well. Clickers are separating and loosing contact. Seems laminating layer of contacts dries out and the clicker part moves beyond the contacts on the board.



Sent from my DROID RAZR using Tapatalk 2