Dyna 2000i Install, a few questions

[Moespeeds]

I'm about to try to put this Dyna 2000i ignition on my bike tonight, and with it sitting on my desk here, it looks pretty simple, but I have a few fast questions. I have an 04 Chopper with the 117ci. From reading some other posts, I'm pretty sure I do not have a VOES sensor, so I will cut this wire and leave it be. Where can I pick up the Tach wire? Under my cam cover it looks like I have the gold cup in there, but I read that guys with 05's don't have this? Wiring diagram looks pretty straight forward, is there anything else I might need here?

Thanks!

 

[Moespeeds]

I just ran home to look at the schematic, looks like I do have a crank sensor. Remember my old TH module is shot. According to the schematic, I've got a green coming out of the EHC going to the TH labeled "tach" and one going into the TH from the timing pickup labeled cam sensor? I'm shooting from memory here, but I was thinking I should grab that green from the EHC and hook it to the tach wire on the Dyna? That's pretty much the only wire I wasn't so sure about, the rest looks ok.

I have a bike builder buddy coming over to help me tonight, I need him to do the static timing anyway. Sul I still have your number, can I call you later and bug you if I need a push?

 

[barhopper]

My green Tach if I recall is going to the tach wire. I think your correct.

 

[Moespeeds]

Got it running guys, and I can't believe the difference it makes. Engine idles and pulls much smoother! Only issue I have is I seem to have lost my low beam? Could I have blown the bulb? I have a spare so I'll change that out tonight. Thanks again!