RRRUFF
Well-Known Member
Finally finished my top end rebuild last night and fired her up.
TP to S&S rockers & boxes, 600 cam, new valves & springs & heads ported by (John Sachs). Started on the first try and sounded great
, no valve train noise.:2thumbs: Let it run for a minute or so and shut her down and looked for leaks. None found. After the motor cooled down I re-started and did another heat cycle. Will do this a couple of more times to seat the gaskets and then ride and tune.:up: Going to add a few more trinkets, levers and flamed primary covers and then good to.
TP to S&S rockers & boxes, 600 cam, new valves & springs & heads ported by (John Sachs). Started on the first try and sounded great, no valve train noise.:2thumbs: Let it run for a minute or so and shut her down and looked for leaks. None found. After the motor cooled down I re-started and did another heat cycle. Will do this a couple of more times to seat the gaskets and then ride and tune.:up: Going to add a few more trinkets, levers and flamed primary covers and then good to.
