Directional

[Michael rogers]

I have an 08 mastiff my right directional front and back dont work i was trying to figure out if its the switch

Sent from my SM-N960U using Tapatalk

 

[knothead]

I have an 08 mastiff my right directional front and back dont work i was trying to figure out if its the switch

Sent from my SM-N960U using Tapatalk

Could be the hand control switch...does everything else work on that right hand control correctly? I mean it could be a short or the switch.[/QUOTE]

 

[Mr. Wright]

It's possible that the plug is coming loose from the pc board.

 

[Michael rogers]

Could be the hand control switch...does everything else work on that right hand control correctly? I mean it could be a short or the switch.

[/QUOTE]Everything works on the switch accept the directional

Sent from my SM-N960U using Tapatalk

 

[mleach72]

Everything works on the switch accept the directional

Sent from my SM-N960U using Tapatalk
[/QUOTE]
It could be the bubble on the pcb board. You can carefully peel it up and clean the contact. It happened to my horn button once.

 

[Michael rogers]

Everything works on the switch accept the directional

Sent from my SM-N960U using Tapatalk

It could be the bubble on the pcb board. You can carefully peel it up and clean the contact. It happened to my horn button once.[/QUOTE]Thanks ill have to check it out

Sent from my SM-N960U using Tapatalk

 

[mleach72]

It could be the bubble on the pcb board. You can carefully peel it up and clean the contact. It happened to my horn button once.

Thanks ill have to check it out

Sent from my SM-N960U using Tapatalk
[/QUOTE]
As Mr. Wright said, check that the plug is fully plugged in. If the directional is on the end of the plug, it may not be making contact, but the rest are.

 

[knothead]

Makes sure u put some dielectric grease in the connector when putting it back together....if u wash the hand control or ride in the rain it can make them corrode with white funk and cause it to do it again