Dead Speedo/Odometer

toodie

toodie

Active Member
Testing Pins

Ok so here is what I have measuring with ohmmeter:

Pin 1/Input >> E2 = 0.0; power/red wire/B31

  • Pin 1/Input >> E4 & E1 = OL

Pin 2/Ground >> E4 = 0.0; ground/black wire/B8
  • Pin 2/Ground >> E1 (signal/green wire/B50) the meter read out flucuates (8.0-9.3) but never goes to OL
    1. Is there an issue with this reading?
  • Pin 2/Ground >> E2(power/red wire/B31) = OL

 
toodie

toodie

Active Member
Preliminary tests look good now just need to get the speedo lens/cover glued back on and will be good to go!! Thanks to Bro1, Earl and Raywood's tutorial on face replace I was able to get the speedo back in working condition:2thumbs::2thumbs:

Honorable mention goes to Bruce even though I was able to figure it out I appreciate his offer to help :up:
 
Raywood

Raywood

The Pirate
Staff member
Calendar Participant
Troop Supporter
Good job Todd, its a bit of a pain huh. Didn't see this thread before but glad you gotter done :)
 
bruce

bruce

Active Member
hey I should get more then honorable mention, I"am the one that told you what was wrong to start with. ONLY KIDDING glad you got it fixed.
 
toodie

toodie

Active Member
bruce said:
hey I should get more then honorable mention, I"am the one that told you what was wrong to start with. ONLY KIDDING glad you got it fixed.
Click to expand...
Ha! You are right and you said nothing to lose by tearing into it :D
Thanks

Now if only I didn't have to go and tear off the trip reset rubber :bang::bang::angry:

 
J

Jrob22oz

Member
Hey I know its kinda late but just seen your post did you get the spots you needed for the re soider if not i can send you a picture of the spots...
 
You must log in or register to reply here.
Top