Carburator overflowing

[francoblay1]

See #38 (Blue O-Ring)

 

[BWG56]

Are you positive about that???? Not in mine mate.

Absolutely positive, and if you look at the view (picture 48) you posted about adjusting the float, you will see the post that the 0-ring is on is much higher than the bowl gasket. The gasket is what always pulls the o-ring off when you lower the bowl without the gasket coming with it.

 

[francoblay1]

Absolutely positive, and if you look at the view (picture 48) you posted about adjusting the float, you will see the post that the 0-ring is on is much higher than the bowl gasket. The gasket is what always pulls the o-ring off when you lower the bowl without the gasket coming with it.

Ok. I am not going to open the Carb now. lol. I can´t remember for sure, but I would swear the gasket was stuck to the the carb´s body when I replaced that blue O-Ring last time.... @KaptinAmerika had to send me a new one as mine was destroyed....

I did replace the gasket too.

 

[BWG56]

Ok. I am not going to open the Carb now.

Ya don't have to, look how much higher the post for the o-ring is than the top of the bowl in the pic, are you drinking again?

 

[francoblay1]

 

[BigTen4]

Here ya go mate.

That blue thingy you talking about is the Ejector Nozzle O-Ring.

Thank you for the manual.