Billet gas cap?
- Thread starter dog1
- Start date
bdmridgeback
Low Down Chop Shop
I will be working on a cap, and actually probably a few designs, as my next venture here.
I have had a lot of call for them and just trying to decide what styles will sell.
I have had a lot of call for them and just trying to decide what styles will sell.
CURDOG
Active Member
Jake, I see you went back to your old avatar. :up:
Hey, I'd be interested in a custom cap. I thought about a flush mount for my Mastiff but never did it.
Dawgboy
Active Member
How about a pop-up that works with the stock paint saver
Chrome (almost) flush mount
I got a spare 'key' from Landmark and took the paint saver rings off no problem.
Make sure you use something to trap all the crud/sealant they use to lock them in place.
Drain your tank first, then use a dust mask which you hold in place with the elastic band. If you still get some pieces of junk in the tank (I did) you'll be able to get it out with a piece of tape on the end of a telescopic magnet or mechanical fingers.
I didn't use pop up gas caps so I can't help with the application there, I scored some chrome gas caps from ET performance and they are sweet. Not very fancy or spikey but I like them and sometimes, less is more.
Fit perfectly, without paint saver rings, and the look is awesome!
Scored these babies a couple of years ago from et-performance.
Welcome to ET Performance !
Here's what they look like. This pic is off the et site but they DO fit that flush!
Here's a pic of them on my bike. You can get an idea of how close to the tank they sit. The chrome finish on this is still like the day I bought them almost 4 years ago. I got a vented and non-vented version and they come with O-rings and seal really good.
Hope this helps.
I got a spare 'key' from Landmark and took the paint saver rings off no problem.
Make sure you use something to trap all the crud/sealant they use to lock them in place.
Drain your tank first, then use a dust mask which you hold in place with the elastic band. If you still get some pieces of junk in the tank (I did) you'll be able to get it out with a piece of tape on the end of a telescopic magnet or mechanical fingers.
I didn't use pop up gas caps so I can't help with the application there, I scored some chrome gas caps from ET performance and they are sweet. Not very fancy or spikey but I like them and sometimes, less is more.
Fit perfectly, without paint saver rings, and the look is awesome!
Scored these babies a couple of years ago from et-performance.
Welcome to ET Performance !
Here's what they look like. This pic is off the et site but they DO fit that flush!
Here's a pic of them on my bike. You can get an idea of how close to the tank they sit. The chrome finish on this is still like the day I bought them almost 4 years ago. I got a vented and non-vented version and they come with O-rings and seal really good.
Hope this helps.
