2010 bagger wont start

[ssinger]

I have a 2010 bulldog bagger put a new battery in it turn key on fuel pump turns on hit the start button nothing the led on ignition light

 

[francoblay1]

Don't you have to push the "Run" button before the "Start" on the 2010 models?

Are you sure you didn't leave any wires behind when reassembling?

Are all wires clean & tight?

Is that new battery fully charged?

First thing I would do, assuming all wires are well placed, is check the battery.... new doesn't mean good....

 

[sixpack]

I know the Owners Manual gives a specific procedure when changing out the battery on these (I have one), but my Manual is 3 states away. If no one else has their Manual close by, try calling a known Big Dog shop (maybe Curtis at WSW or Stroker's Dallas) to get the procedure.

 

[francoblay1]

..............................

 

[francoblay1]

Honestly? SOP ( Standard Operation Procedure) for a battery change?...........

Gezzzzzzzzzzz... and I thought that writing an SSP (Site Security Plan) was complicated..................

GOOGLE it!!!!

 

[Wills67]

1) Lower Kick Stand
2) Make sure beer is cold
3) Find the battery
4) Carry on from there

 

[Razorback]

I have a 2010 bulldog bagger put a new battery in it turn key on fuel pump turns on hit the start button nothing the led on ignition light

This is out of my 2010 Bull Dog Owners Manual. Hope this helps

 

[sixpack]

Razorback, it says "photo not found".

 

[Razorback]

Let's try again. Still getting use to this new site.

 

[francoblay1]

Just realized this Thread is running three times (same question) ........ waste of time respond right here... the OP should delete this one............ pfffffffffff

HERE another one: http://www.bigdogbiker.com/threads/2010-big-dog-bagger-wont-start.73092/

 

[Razorback]

Thanks Franco, I am totally out of the loop on this one.