2007 K9 don,t start

[Guillaume]

Hello I need some help, My K9 don't start check my battery and is full ,if I turn my key normal my oil light comes on ,that is not the case now ,Also my turn light left don't work .
So if turn my key I hear a small click , that's is all .Any help welcome please.
Guillaume

 

[Viking]

Take the gas tank off and check the harness. Also check the circuit board on the handle bar controls. Clean and grease contact points and I'll bet you'll be up and running in no time.

 

[knine08]

I had similar problem. battery read 12 volts but under load dropped to 0 they said it had a bad cell
it would turn lights on but as soon as you hit start button it go dead

 

[Billy the kid]

You probably need a new battery, have it load tested.

 

[woodbutcher]

my '07 seems to be getting a little pissy about starting and everything i can eliminate points in the direction of the right PCB on the handlebar. but all the above items are a possibility.

 

[cdogg556]

Just like all of the above said but if you are running the original EHC in your bike you gotta have 12.75 volts min to have everything work normal, I had the same issues with my bike and finally switched to the ESC from DOC and have never had an issue since, and i never have it on a tender and it sits for 3 weeks sometimes and fires right up no problem, best investment ever on my bike! Good luck!

 

[Dusty.B]

Before you tear your bike apart, try a few things first and eliminate as many potential possibilities, my bikes never had the original ehcs so I can't tell you much about them, but as always check ALL connections for tight fit, twice, just to make sure you didn't overlook anything, if you have the thunder heart ignitiln module check if you get a light on it with the key turned, if you lost your left blinker make sure there's no short anywhere, inside the housing at the connection or anywhere wire may be exposed, a battery load test will eliminate a battery issue, the pcb boards are notorious for shorting out against the housing inside your hand control, one of the screws that hold the pcb board in place can cause it to short to ground, my Docs esc came with a plastic bolt to fix this problem, if you have a multimeter check to see if you're getting any power at the wire going to the starter or at the coil.....just a few things you can check that might get you further