KaptinAmerika
Guru
What he said.
2004 pitbull rip kit install problems
- Thread starter Silverback432
- Start date
Silverback432
Member
Well sadly my fight was against myself this whole time after y’all helping me open my eyes that I had the controls swapped I started looking at oem diagram after y’all saying check cam sensor and noticed speed sensor and cam sensor both have red green and black and I had them backwards all labels were smeared or not fully printed on wires so I kinda guessed on them so I swapped them to just see what would happen and boom cranked and turned on right away would think paying close to 700 bucks they would make sure to send instructions and possibly make up a diagram for the rip kit or just a rookie mistake for me thanks to everyone who made a input on this thread saved me probably thousands with a mechanic in town and from kicking over the bike and calling it a loss lol thanks everyone ...
KaptinAmerika
Guru
All that matters is you got it straightened out.
Now ride it like ya stole it.....lol.
Now ride it like ya stole it.....lol.
pauldeepsea
Guru
Nice work .. time to ride !
KaptinAmerika
Guru
Back when we were selling and installing them we found situations where there was a ground somewhere the bikes electrical and it would cause the Thunderheart Mini Frame module to shut off. I don't know that there are any situations where you could simply say oh the module is at fault since it is issues elsewhere that generally causes the module to stop responding. There are plenty of situations where you could say the RIP kit was at fault...lol. Just like what happened to Silverback.
Silverback432
Member
Yeah bunch mistakes on my end but I’m still blaming the kit to make myself happy lol And also company for not having any type instructions in box as the techs claimed there’s no way I didn’t get any and poorly taged wires I’d say but thank y’all again Wish I woulda found this site 2 weeks ago 
Silverback432
Member
Look like my cam sensor and computer took poop same time now runs but cuts off after heats up ran blow dryer as u said looks like I’ll be ordering one tomorrow lol any reason why my ferrules keep popping out or throttle getting stuck kinda bought this bike knowing need some tlc and didn’t know much about it thanks again for all help here
pauldeepsea
Guru
if your ferrels are popping out your throttle and idle cables may have too much slack in them and need to be adjusted or it may be that you do not have the correct cables. I just experienced an issue with throttle and idle cables that I recently ordered and returned them and went with Barnett cables.
Silverback432
Member
Ah okay I’m thinking my idle cable may be problem replaced it I had took it off and went down to local shop and he ordered me just the idle cable u happen know length of yours? This one was a 37in
pauldeepsea
Guru
Well I am building a ridgeback so mine are longer. I think I have a set from the 04 pitbull you can have for shipping if you want?
Just pm me your address and you can have mine from the pitbull. They are in great condition and are free!
Silverback432
Member
Sweet yeah I’m new this page still I tried clicking on ur profile says I don’t have permission to view ur page could u send me pm and I reply ?
pauldeepsea
Guru
Brother, I apologize I just remember I sold them with a set of grips to another forum member on here, I may still have some laying around and will check tonight and let you know.
