04 Pit Bull Nose cone 107 (Needed)

Energy One
PureDestruction

PureDestruction

Member
I need a new nose cone. Any one no where i can find one other than a big Dog dealer? It seems the previouse owner must have snaped the cam sensor bolt off and tried to drill it out. So basically he ruined it. Thanks :flag:
 
X

X-ray Doc

Member
Try looking at Jireh Cycle first (web site), or J&P cycles.
I have snapped a couple of those weak hold down screws also, but with a small drill bit
and an easy-out I got them out. Becareful on tighting them they will break.
Hope this helps.
 
X

X-ray Doc

Member
Be sure to match what you have with a new one before buying, as there are some with flange style, flangeless style (chrome ring), then there are end oiling style, and newer evo style. Look at the motor where the nose cone bolts on, look to the left of where the breather gear is, about 10:00 oclock, some have 3 small holes and older ones with 4 small holes for oil carry over return,(uses a different gasket also) my 2002 BD motor has the older style 4 holes.
Is your old one beyond repair, could it be drilled out more a put in a threaded insert,
heilcoil?
 
Last edited:
X

X-ray Doc

Member
I would take the nose cone off, and then take it to a machine shop and have them drill
it out and put in a heilcoil or steel insert. If you do take it off, make sure you get the
correct gasket for your style, if you don't you will have problems.
 
X

X-ray Doc

Member
I think so, if not let them drill the orginial hole out and put in the heilcoil and fill the
off center hole with JB weld.
 
You must log in or register to reply here.
Top