Wheel bearings

[flightsafety]

Just installed rear roller bearings on 05 ridgeback. Ordered same part number on old bearing plastic seals. After install the inner race measure. .85 inch. Axle is 1 inch. Do you have to heat bearings and dry ice shaft to install?

Sent from my SM-N950U using Tapatalk

 

[HMAN]

Nope. Sounds like they sold ya the wrong ones. Axle should slide in easy. Slight tap with a rubber mallet may be needed?

 

[knothead]

Like Hman said they gave you the wrong bearing....axle should slide right in with the right bearings

 

[flightsafety]

Just installed rear roller bearings on 05 ridgeback. Ordered same part number on old bearing plastic seals. After install the inner race measure. .85 inch. Axle is 1 inch. Do you have to heat bearings and dry ice shaft to install?

Sent from my SM-N950U using Tapatalk

Without shop manual on chassis, what is the part number for rear wheel bearings?


Sent from my SM-N950U using Tapatalk

 

[Jersey Big Mike]

Without shop manual on chassis, what is the part number for rear wheel bearings?


Sent from my SM-N950U using Tapatalk

Just go to http://wildsteedworx.com/ and locate them.

 

[Mr. Wright]

There should have been a -1 at the end of the number.

 

[flightsafety]

There should have been a -1 at the end of the number.
View attachment 74530

I ordered 1 inch. Actually 25mm x 52mm x 15mm

Sent from my SM-N950U using Tapatalk

 

[flightsafety]

I ordered 1 inch. Actually 25mm x 52mm x 15mm

Sent from my SM-N950U using Tapatalk

Mistake was i didnt measure out of box. Installed em in wheel and then measured after shaft wouldnt go

Sent from my SM-N950U using Tapatalk

 

[HMAN]

Mistake was i didnt measure out of box. Installed em in wheel and then measured after shaft wouldnt go

Sent from my SM-N950U using Tapatalk

Soundz like a post for the new "Fail Forum".