Paint Saver removal Tool

[Ridgeback9040]

I got the paint saver ring from Mr Wright and getting ready to do the job , missing only the removal tool , read forum has 1 running around ...
Can someone let me know if you have 1 available?

Thanks in advance

 

[knothead]

 

[Ridgeback9040]

Thank you , I was hoping to borrow one from someone that’s not using it , I guess I will have to buy one as well ....

 

[Unsprung]

Give it a chance to see if someone comes along and reads this who has one. Most of these guys are a good bunch and won’t mind helping you out.

 

[francoblay1]

Give it a chance to see if someone comes along and reads this who has one. Most of these guys are a good bunch and won’t mind helping you out.

A few years back I got one sent from the US to Spain!!!

 

[Ridgeback9040]

Thank you guys !!
Hopefully someone has one ...

 

[bigdog1rm]

You can use a big bolt that threads in the hole and put a nut on and lock it down and put a 3/4 Ratchet on the bolt head and twist it out.

 

[Ridgeback9040]

You can use a big bolt that threads in the hole and put a nut on and lock it down and put a 3/4 Ratchet on the bolt head and twist it out.

I will have to use the same ring and cap , won’t that damage it or it would twist out easily with some torque ??

 

[Ridgeback9040]

Worse come to worst I just buy the right tool ... and then I would send it to whoever needs it

 

[bigkelk9]

I believe I have it... just made a few moves and finally settling in, but lemme check

 

[Ridgeback9040]

I believe I have it... just made a few moves and finally settling in, but lemme check

That would be great ! Just let me know

 

[bigdog1rm]

I tried the tool could not get it out on mine. I forgot to say use a washer and tape it up after you put the nut on the bolt then thread it in the bung and lock the nut down and then i use a 3/4 inch ratchet with the correct size socket to fit the bolt. Mine came out really easy.

 

[pknowles]

I tried the tool could not get it out on mine. I forgot to say use a washer and tape it up after you put the nut on the bolt then thread it in the bung and lock the nut down and then i use a 3/4 inch ratchet with the correct size socket to fit the bolt. Mine came out really easy.

There was one guy on here that tried beating his out with a hammer and a chisel.
Dont think it ended well