Exhaust

[liferider]

i love my MB mudusa pipes, but....... yep there is always a butt! I have tried everything imaginable but on right turns they drag, sometimes to the point I have to watch my speed. Last year at BB&B ride guys behind me got a spark show a few times. I love the look and really love the sound . Loud as all hell and roar. What are ya'll running and how do they sound?

 

[pauldeepsea]

i love my MB mudusa pipes, but....... yep there is always a butt! I have tried everything imaginable but on right turns they drag, sometimes to the point I have to watch my speed. Last year at BB&B ride guys behind me got a spark show a few times. I love the look and really love the sound . Loud as all hell and roar. What are ya'll running and how do they sound? View attachment 48710

Have you considered cutting some off the edge?

 

[Th3InfamousI]

Have you considered cutting some off the edge?

X2

It's not hard, a little cut off wheel and take your time you can just trim them back just a little bit. You can scallop them or point them like now or it's easier just cut them flat and take off an inch.

Honestly you got a great set of pipes Jonathan and new pipes are hard to find that are any good.

Sent from my 2PS64 using Tapatalk

 

[liferider]

When I cut them, how do I seal the metal so the cut areas do not rust

 

[RC18]

When I cut them, how do I seal the metal so the cut areas do not rust

Maybe?? IDK.....worth a shot

https://www.rustoleum.com/product-catalog/consumer-brands/stops-rust/clear-enamel/


Sent from my iPhone using Tapatalk

 

[RC18]

When I cut them, how do I seal the metal so the cut areas do not rust

Are they rusting now where they've been ground down by concrete?


Sent from my iPhone using Tapatalk

 

[liferider]

Been dragging on the bottom of the cups . Need to cut them just above the MB stamp that's welded on the pipe

 

[pauldeepsea]

Painters tape on the area you are cutting will protect the chrome


Sent from my iPhone using Tapatalk

 

[Th3InfamousI]

When I cut them, how do I seal the metal so the cut areas do not rust

Has the area that youve scraped rusted? Probably not. Neither will the area you cut....

Sent from my 2PS64 using Tapatalk

 

[chubs]

Rust-oleum brand has a high temp clear, in rattle cans, that it says is good up to 2,000 degrees. Ya might give that a look.

 

[HMAN]

Shoot Jonathan, I was dragging pipes too...those MLB Twiztedz on the Pit hang pretty low, well, when you dive deep anyways.

 

[liferider]

Shoot Jonathan, I was dragging pipes too...those MLB Twiztedz on the Pit hang pretty low, well, when you dive deep anyways.

But they look & sound good!