Everything I learned about my DOG was from BDB...so...
- Thread starter Marky-Marc
- Start date
Zach Brown
Member
Just had my tires put on my rims for the rear wheel is the valve stim on the right
Marky-Marc
Well-Known Member
Zach Brown
Member
The guy that done it put it on the right. Does it make a big difference
Zach Brown
Member
Also do you have a pic for the front.I want to make sure the front is not screwed up as well. Thanks
Just flip it over or does that make the tire tread backwards? Might have to swap the hubs because for a fact brake rotor is on the left.
I'd have to see the rims but also might make the rim design backwards? Take a picture?
Sent from my 831C using Tapatalk
Marky-Marc
Well-Known Member
Make sure the tire tread is facing the right way, and the brake rotor goes on the left from behind the bike....if the tread is wrong he put it on backwards....the manual I pasted will show you a break down of it....
Marky-Marc
Well-Known Member
Front tire doesn't matter, when can go on either way, just make sure tread is correct.
Front stem is in the middle anyways so no biggie
I know on my rear rim, I'm trying to flip it in my head and if it was on the right my rim design would flow backwards.
Notice the spikes on the outside of the rim near the valve stem? They would be backwards if I flip it
Sent from my 831C using Tapatalk
Last edited:
Zach Brown
Member
Zach Brown
Member
It's not letting me upload the other pics
Zach Brown
Member
Looking at my rim in the pic I uploaded that would be on the right correct
Those rims don't matter design is the same both ways just make sure tread rolls the right way. In your pic the arrow on the tire should go clockwise to the left
Sent from my 831C using Tapatalk
Zach Brown
Member
The design on the rear is the same but the front is way different.
Marky-Marc
Well-Known Member
@Th3InfamousI, you seem a tad OCD, I mean CDO about your little shark fins my brotha, my front pitchforks run the same either way-going to hell or coming back....
You did bring up a valid point-DEPENDS on the RIMS!!!!
You did bring up a valid point-DEPENDS on the RIMS!!!!
Haha yea on those both my bikes there is a pretty distinct way the rims need to roll. And those shark fins are tapered so the metal is thinner at the smaller portion of the fin and runs thick too end so it would look ass backwards. Although you are probably right most people wouldn't even notice..@Th3InfamousI, you seem a tad OCD, I mean CDO about your little shark fins my brotha, my front pitchforks run the same either way-going to hell or coming back....
You did bring up a valid point-DEPENDS on the RIMS!!!!
View attachment 30413
Ill go back into my OCD hole
Sent from my 831C using Tapatalk
Zach Brown
Member
My rims are different than yours
Letbigdogintocanada
Active Member
Yes,BDB ,great wealth of info,
Yea I get that. That's why I said it doesn't matter after I saw your style
Sent from my 831C using Tapatalk
Zach Brown
Member
Too late now I just paid again to have it fixed.