spadesluck
Active Member
So I purchased the Custom Dynamics White/Amber Ring and was amazed at out how bright the lights are compared to the stockers. I did not think they would make much of a difference at night but they really do add a new dimension. (need an LED headlight now to match)
So after I installed these I promptly when on the search to replace the rear LED's as well. This is just with the running lights on in the daytime. The brakes are very bright.
Not only are these lights better but they also are very well built. They are sealed up on the back side. Unlike our stockers these will stand the test of time. Another plus is they all have a lifetime warranty!
Epoxy sealed on the back:
Stockers left---Custom Dynamics right:
Now if you want to look at purchasing, I purchased the fronts from Ebay. Look for Custom Dynamics White/Amber Ring Harley Bullet FLHX Street Glide. The rears I purchased at Thunder Beach bike rally from a Custom Dynamics booth. You will need to look for the 1157 bullet style turn signal.
Here is a pic of the rear part#
FYI, to install the lights I cut the connectors of the new led lights, stripped back the wire on the ends, then soldered them straight. I then plugged them straight into the connectors on the bike and used electrical tape to secure them in place. I did not want to cut anything on the bike itself. With the ends soldered they fit in real snug, I have no worries of them coming loose.
:up:
So after I installed these I promptly when on the search to replace the rear LED's as well. This is just with the running lights on in the daytime. The brakes are very bright.
Not only are these lights better but they also are very well built. They are sealed up on the back side. Unlike our stockers these will stand the test of time. Another plus is they all have a lifetime warranty!
Epoxy sealed on the back:
Stockers left---Custom Dynamics right:
Now if you want to look at purchasing, I purchased the fronts from Ebay. Look for Custom Dynamics White/Amber Ring Harley Bullet FLHX Street Glide. The rears I purchased at Thunder Beach bike rally from a Custom Dynamics booth. You will need to look for the 1157 bullet style turn signal.
Here is a pic of the rear part#
FYI, to install the lights I cut the connectors of the new led lights, stripped back the wire on the ends, then soldered them straight. I then plugged them straight into the connectors on the bike and used electrical tape to secure them in place. I did not want to cut anything on the bike itself. With the ends soldered they fit in real snug, I have no worries of them coming loose.
:up:
