Dropped a cylinder.....ugh

GDOG_PITBULL

Well-Known Member
Out on the bike yesterday and after a couple of hours I get in some stop and go traffic...little warm out......next thing I know the dog loses power and starts knocking bad.....limp home on half a motor....lots of knocking down below...
Thoughts?:confused:
G
 

Five Five

Well-Known Member
hows your oil level / pressure ?
pull your plugs and take a look at them to determine which cylinder went bad and then I would check the valve adjustments for that cylinder may be a bad lifter... have you tried to fire it up today ?
 
Last edited:

GDOG_PITBULL

Well-Known Member
:whoop: missed a bullet this time....pulled the plugs and one was in bad shape. Cleaned them both and it fired up like nothing ever happened. Going to put a new set in and watch things...could still have plug wire issues, or coil or valves or.....:eek:
G
 

francoblay1

The Spaniard
AND PEOPLE MAKE FUN OF ME FOR CARRYING THIS AROUND WITH ME! I Carry these in my T-Bag & Tour pack of my HD Ultra Classic with a T-wrench along side the caddies.
Just ordered a couple... :D

[ame="http://www.amazon.com/Parts-Unlimited-Spark-Plug-Caddy-2870368/dp/B0022ZU5ZQ/ref=sr_1_2?s=automotive&ie=UTF8&qid=1365615696&sr=1-2&keywords=plug+caddy"]Spark Plug Caddy[/ame]
 

Little-Boo

Well-Known Member
Troop Supporter
Don't forget the Plug wrench :bang: . Happened to me, which is the reason I mention plug wrench. I usually carrying the extra plugs, wires and anit seize in the tool roll. One day the bike developed a miss and I was going to replace the plug, but no wrench WTF. Lucky me it was night time and I could see the wire arcing on to the engine. I took if off and sure enough it had a cut on the bottom side, replace the wire and all was good.

Carlos :D
 
Top