erldawg
Guru
A few weeks ago Little-Boo posted a video about changing cams and lifter adjustment in Germanbiker's thread on lifter bleed down. Here's the link (http://www.bigdogbiker.com/forums/help-wanted/34744-pushrod-adjustment-bleeding-hydros-2.html#post469473 )
I know it's for a Twin Cam but like Justin said it's for all v-twins. With all that said while I was waiting for my lower forks to come back from the chrome shop I performed my usual spring before it hits the road maintenance which included valve adjust as described above. I went three and a half turns on the pushrods. The bike runs like there is no tomorrow and is very quiet at idle. (tick, tick, tick GONE)....
Thank you Little-Boo for sharing that video....:2thumbs:
I know it's for a Twin Cam but like Justin said it's for all v-twins. With all that said while I was waiting for my lower forks to come back from the chrome shop I performed my usual spring before it hits the road maintenance which included valve adjust as described above. I went three and a half turns on the pushrods. The bike runs like there is no tomorrow and is very quiet at idle. (tick, tick, tick GONE)....
Thank you Little-Boo for sharing that video....:2thumbs:
But I'll take the credit :roll: :roll: I used that video to install the cams on my Fat Boy. Followed it to the T and call came out good. 