Go Figure ...

[surferdude]

Last year I installed the Bandit Bruiser Clutch ... I just could not get it adjusted right. It would creep in first gear and just lived with it until a few days ago. Took it to a repair shop to have the stater charging unit replace when my bike died on I-17 going home. Had the mechanic look at my clutch nut since he needed to take off the primary cover. He found that the front nut was loose and that I had put the shiny plates in backwards. I must of missed that part in the instructions. The bike now does not creep in first. Go Figure ... Can't wait to get my WirePlus that's in the mail. Going to have the same mechanic install it. I just don't want to mess it up.
Then I'm going to have a Dakota Digital put in. It's all good. :2thumbs:

 

[Fibersnake]

Good to hear and glad it is working right now. I also installed the Dakota Digital and have been very happy with it.

Went the BDPP PDM route for the EHC replacment, but much success with the Wire Plus.

 

[PurpleDog]

... I had put the shiny plates in backwards. I must of missed that part in the instructions. ....

Good to hear its working fine now for you, but I don't think this is something you missed if you are referring to the clutch pack steels....

 

[05 old dog]

i may be wrong but ive never seen clutch pack steels that were directional....maybe you had a steel in first instead of a fiber....hmmmmm.