New additions to the bike

[05BDog]

These are some of the new items from this winter.

New sissy bar, new coil mount, FU valve caps, spike axle bolts, XXX carb along with a 640 cam bigger valves port and polish and a 40 trim on the jugs. Took it out today for the first time and man does it run. Some othe rthings on the bike are a custom seat, paint work, open primary, 44 mag fork nuts and probably some other things been working on it for 2 years. Excuse the dirt like I said I just came in from riding

 

[Chopper Dave]

Scoot looks Sick! love the open belt and the paint!:up: good job!

 

[Raywood]

Looking great 05Bdog, like the superman emblem on the bars! How did you do it?

Have one question. Is there some kind of bracket that I don't see holding up that carburator??

Great job,
Ray

 

[Chopper Dave]

Looking great 05Bdog, like the superman emblem on the bars! How did you do it?

Have one question. Is there some kind of bracket that I don't see holding up that carburator??

Great job,
Ray

I noticed that also Ray.....didn't see a bracket of some sort.....

 

[Big Ron]

Very....Very....Nice:2thumbs:

 

[WB Cycles]

Outstanding !!:2thumbs:

 

[05BDog]

Thanks guys. Yes there is a bracket you can see it on the left in the picture its chrome. I will get a better picture and post it.

Outstanding !!:2thumbs:

 

[Gas Man]

Is that a RMD open belt?

What about the coil mount setup.... all Vulcan? or did you run a yankee motor mount?

 

[woodbutcher]

lookin' great! where did you get the hooded turn signal bezels with the dimpled lenses, if you don't mind me asking? :2thumbs:

 

[lee]

quality is that - same exhaust as me by the looks of it - AN Smoothness???

 

[rufroggy]

Very nice setup!

 

[05BDog]

RMD open belt the coil pieces came from Vulcan but I had to machine the motor mount to make it work. All the visors for the tail lights can from my local H-D Dealer. Thanks again for the compliments

 

[05BDog]

Yea the exhaust is AN smoothness love the sound

 

[lee]

i put heat wrap and torque cones in mine

 

[Gas Man]

RMD open belt the coil pieces came from Vulcan but I had to machine the motor mount to make it work. All the visors for the tail lights can from my local H-D Dealer. Thanks again for the compliments

Yeah I got the RMD sitting, awaiting to be put on... I got a yankee motor mount, with a vulcan coil mount... got to get even the yankee motor mount milled and "adjusted" to fit it?

What was the adjustments you needed to make to get yours to fit?

And Wood... you will see a few of us have those signal bezles. I got them on mine too!

 

[BBChopper]

:2thumbs: damn good!

 

[05BDog]

Gas mine was 1/4 inch to thick on the back side milled it down to match the factory piece I took off.

 

[Mario77746]

Sharp bike man!

 

[cavracer21]

awesome ride man. top self.

 

[PROFLYER]

Looks great!

And guys, if you look close under the carb you'll see the "S&S" carb support bracket. You turn it down under the nut that's between the jugs and the bottom carb bolt between the intake and the bottom carb mount bolt. They work perfect and really clean up around the carb. Plus they're only 15 bucks...just did one on mine for my new cleaner!