Drag Pipes

Energy One

KnotSo

Admin
Staff member
I looked up Raywoods exhaust pipe once and saw the same Bolt / Washer set up, and it works! :2thumbs:
 

Raywood

The Pirate
Staff member
Calendar Participant
Troop Supporter
I looked up Raywoods exhaust pipe once and saw the same Bolt / Washer set up, and it works! :2thumbs:
I posted this recently somewhere on here. It's popular and listed on the nightrider website.


 

lee

Well-Known Member
I think I'll give it a try - will I have to mess with the carb after doing that?
 

go4dave

Member
this looks like a very good idea.. and i know, that back pressure is needed to build the most torque. What is the distance from the exhaust port,, to the "modified" baffle? Is there a proper distance, then variables to that?? Both cylinders should be the same (i lean towards yes)?
 

lee

Well-Known Member
this looks like a very good idea.. and i know, that back pressure is needed to build the most torque. What is the distance from the exhaust port,, to the "modified" baffle? Is there a proper distance, then variables to that?? Both cylinders should be the same (i lean towards yes)?
Probably impossible to say cus it will depend on your particular set up / exhaust diameter etc - it says to put them in near the end - you could also put the power cones in to help stop the exhaust gases getting back in through the port although I think our cylinders might have a step in the port to help with this
 

lee

Well-Known Member
who ever gave me a rep point I thank you for it - I wasn't expecting one of those for at least a couple of years!
 

Gas Man

Cool isn't cheap
Calendar Participant
Click "Quick Links" then "User CP"... it might have been me... I don't remember so i'll rep ya just for shits
 
Top