Wanted : primary vent button

[Jokerhd13]

I pulled the primary vent button to clean it and when i was putting it back the POS snapped .It wasn't even shouldered yet ! So I am looking for a replacement or an alternative.I need to get this bike back up ASAP.The reason i pulled it is because my starter started blowing oil again .Its a 6 week old accumax starter.I was hoping to just pull the vent button, clean it and be back down the road.Thoughts ,ideas?

 

[nine lives]

Get a barbed hose fitting,screw it in where your vent was, run a hose down the back side of the primary and put a small breather filter on the hose, finish running hose out through the bottom of the frame.

 

[Claymation]

Get a barbed hose fitting,screw it in where your vent was, run a hose down the back side of the primary and put a small breather filter on the hose, finish running hose out through the bottom of the frame.

Good idea, i put the button vent in as well, but it seeps primary fluid.

 

[Bobby Schulz]

You can get them from Bikers dream in AL. if you want the stock style.
Or you can do as the others have said.

 

[Jokerhd13]

The thread is like 10/32,i am going to look around for a barbed fitting that small.

 

[PHATASS]

The thread is like 10/32,i am going to look around for a barbed fitting that small.

Just sheared mine again and was curious if you found a barbed fitting? Thanks!