Oxygen Sensor

[Vince Koehn]

Hi,
Does anyone know if there are shorter oxygen sensors available somewhere? I welded the oxygen bungs in my pipes and apparently the V&H pipes fit a little tighter to the motor as the rear sensor hits. The angle is right, however I should have welded it in at a different angle to help give it clearance. These sensors are quite a bit longer than a Harley sensor. The easy fix would be to replace the sensor.

Thanks, Vince

 

[BBChopper]

Well thats a new one for me!!!! My O2 iz for hang overs!!!:2thumbs:

 

[lee]

These sensors are quite a bit longer than a Harley sensor

ok I'll bite - get a sensor from Harley? I think the O2 sensors are a pretty standard thread size albeit I can't remember what it is

 

[BigDogBro1]

Call S&S engines.

 

[pknowles]

Two different sizes.12 and 18 mm. Use a torch and heat the pipe/bend the Bung up/down enough to fit the sensor.remove sensor before heating.

 

[Vince Koehn]

I heated it up right around the bung and moved about 1/8". Perfect! Thanks for the suggestion!

 

[Little-Boo]

I heated it up right around the bung and moved about 1/8". Perfect! Thanks for the suggestion!

Next time measure twice, mark and then cut or weld.

Carlos :2thumbs: