FS: Karata 4” Open Primary—SOLD!!

Energy One

SKOGDOG

One of the old ones.
This open primary was on the bike when I bought it, and has about 20,000 miles on it. It has a new clutch sleeve and pac of discs, and is complete—ready to install. The outer bearing support is called the Gillette. The Karata primary is not made anymore, but Karata does have most parts to support existing owners.
Also included is an extra 4” drive belt for it, and changed it recently after an unfortunate incident on a gravel road while riding the Three Sisters in TX. The original one has a few small but unsightly holes from a few pieces gravel. A145B68C-0618-4FDA-8313-9ED9760EBD47.jpeg470ED9AB-C0C9-4A00-A619-C4548850B430.jpeg68DE6030-24C9-47C6-AF67-4D5039213D9A.jpeg
It has a few small imperfections, but the only flaw is a scrape on the lowest part of the OBS that hit the concrete when going into a driveway, but that polished out pretty well and is not noticeable. The clutch sleeve in the photo has been replaced since the pic was taken.
The open primary does take your bike to the next level—it is easily installed and requires very little maintenance. Of course no oil. It does make a whine, which many think sounds like a supercharger-some don’t like it, but I did.
There are several threads on this Forum about open primaries—I suggest you read them.
I am asking $2,950 plus shipping.
I’m happy to answer any questions, but please direct all negotiations to: K9biker@icloud.com
 
Last edited:
Nice looking primary, I just placed an order last week for a baker open primary along with a 32 tooth drive pulley it cost me about the same as what your asking for yours but the baker unit doesn’t have as wide of a belt as yours. Very cool piece.
 
For some reason I thought they had quit making them for our bikes. I know they don"t have any for the 2010 bulldog.
Per Linda Wash at Baker, lindawash@bakerdrivetrain.com, they will not be making anymore belt drives for the BDs. There are a few floating around out there but again according to Linda no more will be made.
Unless of course something we're to happen that BDs were being manufactured again and then I'm sure, if the price point was there for them, they would start up again.
 
I placed my order just about a week ago and have an estimated arrival time approximately 2 weeks from the order date, I touched base with the manufacturer today via internet and was told it’s being manufactured at this time and eta is on time. The dealer I placed the order through also confirmed this information for me.
 
The 330 Ridgebacks additional offset is handled on the right side of the transmission so I would think that it probably would fit. But I don't believe Karata ever made it specfically for the 330 Ridgebacks so without measuring everything and test fitting to verify I can't say for sure.
 
Can someone tell me if this can be made to fit the 2009 Ridgeback
It will fit the rsd 300 tire and 330 Tire they are the same for baker open primaries but you may need to remove your easy pull ball and ramp baker has a different part number for 08 and up with the easy pull and I’m assuming it’s got to do with that part
 

Th3InfamousI

Administrator
Staff member
Shouldn't be any issues, Inner Primary offset is the same for all 05-11. Nothing changed on the Left Side
 
Top