Clutch

PROFLYER

PROFLYER

SWOLE
just pack it like you would any other bearing set. I used a full synthetic grease like you would for a wheel bearing when I put mine all back together when I switched the pulley out. Cleaned it out really well with brake clean and re-packed it. Then I put a nice film of the same grease all over the rod before I pushed it back through the tranny. If you don't have grease in there, it can bind up.
 
S

Sven

Well-Known Member
Pack the hole and push the rod in it. Rod ends should be torn up not smooth like a ball bearing if chasing a noise like I'm guessing.
 
Michael rogers

Michael rogers

Member
Sven said:
Pack the hole and push the rod in it. Rod ends should be torn up not smooth like a ball bearing if chasing a noise like I'm guessing.
Click to expand...
Just wanted say thank you for your help I greased the ball and ramp I greased the clutch rod it still was squeaking I found that my rear tire wasn't aligned properly so the belt was rubbing I realigned the tire no more squeaking

Sent from my SM-N960U using Tapatalk
 
You must log in or register to reply here.
Top