Baker Builder in Tampa

[vej]

3rd gear popping in and out for the second time... last time i replaced trashed bearings and shift forks that looked good... anyone in the Tampa area that can built proof this thing?

 

[pknowles]

Someone just posted on here about Baker running a special on these gearbox rebuilds. I would check them out first.

 

[farmall]

Dogs and slots tend to round off at the same time. I'd yank it then send it to Baker unless wear is obvious under magnification and bright light. I'm buying an LSD OD 6 if I can't find a donor bike first (since a Baker = a large chunk of used donor and I'd get the rest of the motorcycle) and found this on backcut gears, relevant if standard ain't doing it for you:

Back Cut gears on a Harley - Harley Davidson Forums

Primary/Transmission/Driveline/Clutch - Back Cut gears on a Harley - I own a 25 year old Harley FXR that is totally customized and am told has back cut gears in the transmission. It always amazes me how smooth the transmission shifts with never so much as a clunk when going into 1st or any other...

www.hdforums.com