2005 Pitbull speedo/tach/console

[LittleE]

:bang: I seem to have lost the couple of the screws (middle and left as you look up from the front end) that hold this console down. I think I hahve a couple of these screws and seems like the plastic bushings are still there but I was hoping somebody may have a diagram of what the correct install looks like.

 

[Fibersnake]

Should be one bolt and nut in the center that holds mount and it is adjustable. Then there will be two fine machine screw on each side that go through bracket to consul. These screw just go through the slots of the mount and screw in to the counsul but have some slot to allow for alignment.

On my 05 Mastiff, just start one (use a little blue loctite to keep from loosing the screws) then the other, then have some hold it in place (center) and then tighten down (just good and snug-do not overtighten).

 

[LittleE]

Thanks,

Finally got it repaired. Comoco faxed me diagrams and I fixed it. :2thumbs: