At this rate he is going to have to give his EHC away ...hahaSure ya can!Just be sure to "pay it forward" and help out another member sometime!
Yellow Bitch Down, Need Bearings.
- Thread starter francoblay1
- Start date
liferider
Looking forward to retirement
That's because it's a worthy causeThis is the only thread longer than the TEXAS RIDE THREAD that I have seen lately
toomanybikes
not enough time 4 riding
Posts about how Franco messed up his rear axle, spacers, and bearings, post with part numbers and spacer specifications, posts about Franco having a mechanic do the work and Franco's lack of tool are probably 100 or more of the posts. Now if the weather was nice in more of the US, Franco might still be looking for parts and information because we would all be out riding.133 posts to get 5 bearings moving
francoblay1
The Spaniard
Sir, Yes Sir. ................
francoblay1
The Spaniard
BTW.......... I am not sure now.... 
Must be a government job!!133 posts to get 5 bearings moving
francoblay1
The Spaniard
Marky-Marc
Well-Known Member
Ker (@BWG56) you ARE MY DADDY!!!! Your measurements are spot on.....shipping these out to the 'rent money, bitch down WANKER (@francoblay1) tomorrow....ill keep the shinier ones though....bwahahaha
Marky-Marc
Well-Known Member
Will send ALL THESE SPACERS as a damn Puzzle to @francoblay1 so he actually has to MAYBE LEARN how to use a damn tape measure (METRIC and ENGLISH) and figure out which spacer goes WHERE.....bwaahahahaha
Marky-Marc
Well-Known Member
Thanks (@BWG56) Ker for the measurements....ill make the puzzle easier for our beloved WANKER!!!(@francoblay1)
BWG56
Guru
That's fantastic Marc.
You are my new DADDY, great job and fast turn around also, let me know if you need a drawing on anything else, maybe I should just reverse engineer the bike and post a complete set of drawings, ain't like I don't have experience drawing after 42 yrsBut again kudos to you Marc for making them
Last edited:
BWG56
Guru
SWEET
Marky-Marc
Well-Known Member
Waiting for your CAMEO and breaking the camera Brother.....That's fantastic Marc.
But again kudos to you Marc for making them
chubs
Guru
Okay gimme a sec here to get directions. Okay. Head west till ya come to Iowa, then turn which way? Left or right? Or would it be quicker to go to Nebraska, then make a U turn? And to clarify things do I need to borrow Ker's apron? You know, ta keep the ol tallywhacker outta the grease and oil? Leave the porch light on, I don't get off work till 0700!
Marky-Marc
Well-Known Member
turn north for 2.632 miles, then, turn east by the old barn that USED to be there, by the old oak tree that was pulled out 2 years ago, at that point, then go west for 5.62 miles until you see the old rusted model T...then...well FUCK, you are LOST!
405bigdog
Active Member
Sven?