My map is crap-ping out. Watt gives? Basics 101
- Thread starter Sven
- Start date
erldawg
Guru
Good one Mad Dog :roll::roll::roll::roll:
armad
Active Member
that was Sven, a few years ago, splaining analog entabulators. Now the terminology has changed and everything is digital. Hence 1-0-1-0-1-0-1 etc. Computers the newer ones now use BCD, groups of four 1010-1010-1010 etc. much faster and much greater capacity for data. I am sure Sven will chime in here to further splain it.
Come on, Brew, are you kidding? You don't think I'm all upset do you? It was the comment at the end... "I'm watching your abstract" is more like goof on it. I'm flipping the pages, pointing out, 'well it says right here' and then I start to laugh. You all start to laugh. Who is getting mad/upset/or??? >>> :roll:
Someone wants to know where the bike(s) are? I keep saying, I can back up my world of what is called, watt? "Wire & Fire?" This is like a recipe. Throw the parts in a box. I'll figure it out. Parts is parts. Parts only assemble one way. You get electricity wrong, well, she no start, right? Gas no go? Compression, don't you know?
This [was] bulletproof. I found out later, he was beating the crap out of the bike. A drunk took him out at an intersection. This totaled the bike. He bought it back from the insurance co. Bought another frame and front end. Plopped the engine in. Thus begins Bike #2.
If you want to ear engine sounds, I have bulletpoo on the video chitting some sounds. All I did was assemble the parts per shop manual. A little EOIC to the valve adjust. A VOES installed. An ignition timing adjustment. What else is left?
No pop out of the carb. No knock in the wrong gear. No nose dropping on throttle apply. Thing was well balanced and handled decent. Bike #3 is Shovelicious. Technically, she is done. However, she needs a machined wheel spacer made. Come to find out they are no longer available from the oem dealer. So now she sits. Bike #4 has already begun. I haven't seen the parts, but this frame has already been painted.
Anyone who takes on a build from scratch, knows how long it takes to gather parts, have that look and all of a sudden??? That time of his goes so fast. I'm waiting for his; new round of bars; new round of tanks; his every flavor of the month parts...
Something stops the build. That is the fun part(s).
Here is shesquidly, thinking he'll get to my place before the sissy takes a ding to the top of his head. The bottom fender bolt backed out he was so lucky [again]!
Swap Meet Build.wmv - YouTube
ChopperShakeDown Run.wmv - YouTube
Someone wants to know where the bike(s) are? I keep saying, I can back up my world of what is called, watt? "Wire & Fire?" This is like a recipe. Throw the parts in a box. I'll figure it out. Parts is parts. Parts only assemble one way. You get electricity wrong, well, she no start, right? Gas no go? Compression, don't you know?
This [was] bulletproof. I found out later, he was beating the crap out of the bike. A drunk took him out at an intersection. This totaled the bike. He bought it back from the insurance co. Bought another frame and front end. Plopped the engine in. Thus begins Bike #2.
If you want to ear engine sounds, I have bulletpoo on the video chitting some sounds. All I did was assemble the parts per shop manual. A little EOIC to the valve adjust. A VOES installed. An ignition timing adjustment. What else is left?
No pop out of the carb. No knock in the wrong gear. No nose dropping on throttle apply. Thing was well balanced and handled decent. Bike #3 is Shovelicious. Technically, she is done. However, she needs a machined wheel spacer made. Come to find out they are no longer available from the oem dealer. So now she sits. Bike #4 has already begun. I haven't seen the parts, but this frame has already been painted.
Anyone who takes on a build from scratch, knows how long it takes to gather parts, have that look and all of a sudden??? That time of his goes so fast. I'm waiting for his; new round of bars; new round of tanks; his every flavor of the month parts...
Something stops the build. That is the fun part(s). Here is shesquidly, thinking he'll get to my place before the sissy takes a ding to the top of his head. The bottom fender bolt backed out he was so lucky [again]!
Swap Meet Build.wmv - YouTube
ChopperShakeDown Run.wmv - YouTube
Binary-coded decimal - Wikipedia, the free encyclopediathat was Sven, a few years ago, splaining analog entabulators. Now the terminology has changed and everything is digital. Hence 1-0-1-0-1-0-1 etc. Computers the newer ones now use BCD, groups of four 1010-1010-1010 etc. much faster and much greater capacity for data. I am sure Sven will chime in here to further splain it.
Bi-quinary coded decimal - Wikipedia, the free encyclopedia
armad, This is more another way to carry bytes faster. I think BCD has been in the box? It sounds like old 1960's IBM generic? It has to make some fast calcs. But this more we discuss the tuning aspect of the piggy unit. I think you may have brought in a wrist pin to the engine, or a 220 ohm's resistor for a motherboard? It is sort of related, but then again not. However, you did send me to the 'quinary' part of the concept:
If you look at this as your X and Y, look how you toggle the boxes. It says, you can jet up a square, you can jet down a square. Those that watched that injector move on the spray on/spray off? It sort of moved like this...
... The numbers above, rep that 0 to 9 split. Call this, the low to mid/mid to WOT range. Notice the injector at the top of the velocity stack, only runs at mid to WOT. Consider that 4.9999999 about to run from Low-mid-to-mid WOT.
Those that watched the shakedown vid, the part where the kick start out of the spark plug hole, the vid then sees some woman on the ground after she tried to kick it? Anywho, notice the analog TV screen. Notice the 60 seconds of that light flickering, and then the horizontal lines begin to split the screen.
Is that not more evidence that man has to follow that phenom of the 60mhz is that screen? That the 0 to 9 is that mathematical split
Are we on the same page yet? Have I shown you enough evidence? Have I shown you the tumbles? The TV screen/the 0 to 9 split/the 60 cycles to break the screen up/you as the witness to the "Alpha" signal.
Watch my wallet swing on my key chain. You are getting sleep pee. Your eye lids are heavy with Barnett clutch fiber dust. You can't stop yawning. You are...
Nukeranger
Nukeranger
X2 - I have asked this simple question before with no answer. I think Sven is full of shit.
pknowles
RETIRED
Sevn is just like my old lady sometimes, she says I just don't understand what shes sayingX2 - I have asked this simple question before with no answer. I think Sven is full of shit.
ok dearGo up to post #28 >> Very bottom are 2 videos << Click on the url'sX2 - I have asked this simple question before with no answer. I think Sven is full of shit.
Does the bike rack look the same in this pic as in the vid? You hand me the parts, I have to come up with your, "I want it dis way" and I meguyveer it dat way. And if you don't like how it came out... Then, why bring it to me? Put it together your way.
In the meantime, I am waiting for parts for 3 other bikes. I come here to hear your headaches. Is? You Pee, Yes, someone is at the door with another part that does not fit. See me having a fit? No. I make it fit and finish it.
Is mickey mouse my middle name?
I forgot my ears dis morning.Where is she? Get her over here. Mrs. Lady? I am here with a few fell ears. I've been explaining things out of, "Chew Ya Child's Pay Book." Dare are days I wake up, chew on my cabbage twice aroundear. Day have no clue about WATT Dime talking about either.Sevn is just like my old lady sometimes, she says I just don't understand what shes saying
My guess is you are probably right about something, Sweetheart. Men just don't understand women like I do. She is on the rack right now. If you do not see it her way. If you do not like it, you pay with what he swings all 3 legs over her/you/watts the difference?
No offense, Mrs. Lady, butt some men are the plumbers, some men call the plumber. I might find some [ear], paying out of pocket. I'm not pointing fingers. Just say'inn.
You guys! :roll:
Morning, Pee Key. :Yawn:
stlmikie
I wish I had more money.
The part that blows my mind are the guys that talk so much shit. IF YOU DON'T LIKE WHAT HE'S SAYING MOVE THE FUCK ON! Don't read the posts, move to the show and shine section or the alley! A couple of us are getting something from this. Don't fuck it up for us because you don't get it!
Nukeranger
Nukeranger
Ok, I found a couple of pictures. So what. http://www.bigdogbiker.com/forums/efi-topics/33968-efi-thelixiripoff-explained-101-1-a-2.html
The YouTube video is crap just like you brain. As far as I can tell, you are from Europe and you smoke too much weed. Looking at the wiring in another post, I wouldn't let you touch or look at my bike. It also shows you don't know crap about wiring.
I almost wish I could apologize for my thoughts but you are a Knucklehead.
The YouTube video is crap just like you brain. As far as I can tell, you are from Europe and you smoke too much weed. Looking at the wiring in another post, I wouldn't let you touch or look at my bike. It also shows you don't know crap about wiring.
I almost wish I could apologize for my thoughts but you are a Knucklehead.
stlmikie
I wish I had more money.
DemonK9
Active Member
Such confusion, hostility, and name calling.... I think this was an excellent post, not only did I actually read this 3 or 4 times over to profile this Sven, I enjoy his other post also. To say, very intertaining. I found the "I want to be the trees lawyer" the best yet. I have watched his videos, read over all his previous posts have found this game actually quite entertaining in figuring out what is/who is Sven. I was actually suprized in his braking his own rules and showing or proving himself to any one of you of his bikes. Looking at his videos evaluate the car license plates. Look at his surrounding. His lack of or no information is the most fun to figure out. The spider theme is most curious. But the name least of all I would expect more, a more original, someone wih more intelligence then Kevin Spacey..... In wood shop the saw blade was alway broke, but I could always count on the drinking fountain, I might have Not received an ice cube. I was alway quenched.