PVc braided line

[alhall88]

While doing some tuning and many jet changes, I decided I can't stand that steel braided line anymore. I went with this old look but a newer material from Motion Pro. Also used the special clamps for a cleaner look.

 

[alhall88]

 

[alhall88]

 

[alhall88]

 

[V]

Looks good Al
Is that a Doherty plate? Will your carb bowl drop and clear with out removal of the plate?

I've been lookin at that set up.

Thanks V

 

[alhall88]

Yep it is, dropped it 4 times today with some jet changes and never had to remove the backing plate when I dropped the bowl.

 

[Alicat]

Looks clean, I like it! What did you cut it with, the crimper?
the Other Al

 

[alhall88]

No AL, just a regular knife or switchblade whichever is in your pocket.

 

[Raywood]

Very nice Al, I would like to do that material myself as it won't wear against the engine. Where did you order it from?

Thanks,
Ray

 

[Chopper Dave]

looks good Al! :up: I have used those clamps before.....we use them on some of the water lines that are on the molds that we run in the machines....but they are the bigger version....

 

[Gas Man]

That's another way to go... got to be easier to use.

Is it certified for petro?

 

[lee]

looks good Al, I especially like the clamps. You do need to get on top of your polishing though!

 

[alhall88]

Gas yep thats what is/fuel line, I was lucky that it came in all 3 sizes. And Ray I just ordered it direct from motion pro. Motion Pro - Quality Motorcycle Cables, Tools and Controls

If you have to remove the line you break it off with the crimping tool. I did not use one of the clamps on the petcock of the fuel tank however, just in case I'm on the road somewhere an I would have to pull the tank.

 

[Cutter]

Looks great Al... as usual :2thumbs:

I am wondering about yellowing?

 

[Gas Man]

Good deal Al... was this a cosmetic only mod for you?

 

[jimizee028]

al i like it

 

[alhall88]

Good deal Al... was this a cosmetic only mod for you?

No that stainless shit is scratching my paint,motor and you can't use the teflon stuff for fuel line. Plus that shit is a bitch to work with.

 

[alhall88]

Looks great Al... as usual :2thumbs:

I am wondering about yellowing?

Well its not supposed to yellow or get stiff. But at that price if it did I would just replace it.

 

[slowrower]

What sizes did you order? 5/16" for the Fuel Line ... ?

 

[alhall88]

rear cylinder vent=3/8
front cylinder vent=3/16
fuel line=5/16