Looking for Low Boy sissy bar for 250 tire 06 through 11. I've seen them but were always home made, and that's ok.
Well most everything in 2007 was a 300, i honestly didnt know they made the chopper in 2007, i thought it ended in 2006 and the k9 took its place in 2007. But good to know there was 1 model in 2007 with a 250. Last time i talked to ginz, it was hoing to be around 1,000 for bar and pad with me suppling the plate. I just have held off in hopes of finding one cheaper. I already bought 2 bars, mount plates, backrest they made me for the bagger (not lowboy ones) and all that was about 1,000 so trying to justify ordering a 3rd bar for the bagger and 1 for the Mastiff.Well I have a 2007 chopper with a 250 rear tire on it that I bought brand new, so you may be off by a year on your figures there. But thanks for the info. I already spoke with Ginz about making one for me. May need to go that wrought.
Yeah I contacted them also, I luckily found one at Ross Cycles before i actually knew who and what they are about. But he charged me 900 for the mustang seat without the driver backrest. And at this time I still had no sissy bar for it. I then had Ginz make me a set of side plates that mount where the factory ones do, and 2 sissy bars and a single backrest. Even tho the backrest wasn't what i was thinking when he said 8 inches long I thought he meant horizontal not vertical. The sissy bars are the same difference is one has luggage rack one doesn't. But here is a picture of what they made for $1,000 dollars.I have been holding off buying one from Ginz for my bagger hoping a low boy would come up for sale somewhere. I contacted Mustang seats about there kit for the bagger they made years ago but they said they no longer make it. Has anyone ever asked Donna and Derek to make a few?
I'll contact ginz and see about what the cost of a bar and pad is, and if someone on the form has one that they could give the the overall height, height to first bend, height to second bend and overall width center hole to center hole for mounting I'd be glad to find out what i can, I can get specs of plate from Donna.If you do that I would be in for one also depending on total cost of course.
Me and Erine12 is having Ginz make us each one for our bike, well actually I'm having 2 made one for the Mastiff and one for the bagger. You might want to call them while they still have my backrest plate to design the pad. You'll have to buy a backrest pad from Donna or Eric at bigdogpartskingpin.com tho. And last I checked they only had like 2 left. But just wanted to give you an update on these. Mine will be shipping out from Ginz Choppers on 8-28-20. I'll post pictures once I have them.