electronics

G

Gary W.

New Member
i am looking for a ignition control module for a 1996 vintage classic. The bike however was built by Vick Edelbrok's race team! I do not no if the module is still stock,or not. If the bike is built,can you run the factory module,or do you need more volts ?
 
Mikeinjersey

Mikeinjersey

Well-Known Member
Gary W. said:
i am looking for a ignition control module for a 1996 vintage classic. The bike however was built by Vick Edelbrok's race team! I do not no if the module is still stock,or not. If the bike is built,can you run the factory module,or do you need more volts ?
Click to expand...
Some people on this site have a good knowledge of the Vintage bikes. Are you certain you need a control module? Wait for someone here to help you troubleshoot and isolate your problem before buying a new module. Cam sensors are more likely to fail rather than the ignition module itself.
 
HMAN

HMAN

I just like my Freedom
Knothead is the local legend when it comes to this model. He just sold his baby too. He is working his tail off but should be along shortly. Pull up a chair while you wait and have a read..

1996 Big Dog Vintage parts list

1996 Big Dog Vintage parts list...most part are drag specialties or v-twin....parts very from 1967-1986...harley wide glide FXWG ,FLH and fxr... 1...GMA doesnt have these 10" front disc so v-twin does in a different style... part number 23-0311 or your choice 2...Front wheel 40 spoke dual...
www.bigdogbiker.com
 
Jersey Big Mike

Jersey Big Mike

100K mile club
knothead said:
Mick is correct with his questions. Answer those and maybe we can help you... but with that said most likely you have a Dyna 2000 or a Ultima ignition module...these module are the cam sensor and ignition module in one
Click to expand...
Personally on that era bike and ignition and sensor in one, I would go with the Daytonna TwinTech unit -- serverd me very well on my pre-BDM bike.
 
You must log in or register to reply here.
Top