Welcome to Our Community

Wanting to join the rest of our members? Feel free to sign up today.

Sign Up

small seal on shaft baker RSD behind cluth?

Discussion in 'How-To' started by frenchie, Sep 27, 2017.

  1. frenchie

    frenchie New Member

    Joined:
    Sep 1, 2017
    Messages:
    11
    Likes Received:
    5
    Trophy Points:
    3
    Location:
    france
    My Bike(s):
    big dog K9 2007
    First Name:
    frenchie
    hello, I need some information?
    I am in the process of replacing the baker clutch bell by a complete bandit clutch kit.
    has uninstallation, behind the bell, I saw this small seal, I think it is placed behind the clutch bell, but I'm afraid to crush it to tightening ...
    where exactly is it installed? I put a picture
    Thank you for your help
     
  2. FrankBDPS

    FrankBDPS Well-Known Member

    Joined:
    Sep 7, 2013
    Messages:
    3,329
    Likes Received:
    3,089
    Trophy Points:
    113
    Location:
    North Lawrence,Ohio
    My Bike(s):
    2ooo ProSport 1997 Honda Night Hawk
    First Name:
    Frank
    Try to contact Andrew Barnes at Barnes performance motorcycles in Endwell New York. He used to have a web site on the internet. Good luck!
     
  3. Mr. Wright

    Mr. Wright Guru
    Supporting Member

    Joined:
    Aug 27, 2012
    Messages:
    7,815
    Likes Received:
    11,120
    Trophy Points:
    113
    Location:
    Salem, Missouri
    My Bike(s):
    04 BD Chopper- 2002 1100 v-star
    First Name:
    Shannon
    If your talking about the little o-ring behind the clutch basket, yes, it just slides on the shaft and it is pinched as you tighten the hub nut. Don't forget lots of red lock tight on the hub nut.
     
  4. frenchie

    frenchie New Member

    Joined:
    Sep 1, 2017
    Messages:
    11
    Likes Received:
    5
    Trophy Points:
    3
    Location:
    france
    My Bike(s):
    big dog K9 2007
    First Name:
    frenchie
    A big thank-you.
    it's really nice not to feel abandoned, I asked the question to baker who did not answer ....
    by cons when I try to load a picture of even reduced size, it does not work at this time ...
     
    Mr. Wright likes this.
  5. frenchie

    frenchie New Member

    Joined:
    Sep 1, 2017
    Messages:
    11
    Likes Received:
    5
    Trophy Points:
    3
    Location:
    france
    My Bike(s):
    big dog K9 2007
    First Name:
    frenchie
    hello

    how many shim do you use on the springs of the pressure plate for the installation of a complete bandit cluth kit?
    I put 3 shim of 050 " to try, total 150" I do musculation but with the clutch and 3 shim it is already very hard to disengage!
     

Share This Page